User Guide

PAMS
Technical Documentation
NSE–5
Service Software Instructions
Page 9
Issue 1 07/99
Installing the Software on PC Hard Disk
The program is delivered on a diskette and is copy protected with a
dongle PKD–1. It must be present in parallel port when using Service
software.
The program must be installed on the hard disk before use.
Keep the original diskette safe to enable upgrading of the program !
If you plan to use PCL Start service software, you must install it before
installing Service software, see PCL Start installation instructions.
First time installation of WinTesla:
Do the following to make a complete WinTesla installation with support for
NSE–5:
Insert the WinTesla software diskette
into the floppy drive on your computer (i.e. Drive A:)
For Windows 3.1 and 3.11:
start Windows, type win <Enter>
Open the File manager, open Main window and start File
manager.
Select the floppy drive and:
For Windows 95 and NT:
Open Microsoft Explorer,Select Start –Programs – Explorer
Select the floppy drive and:
Start installation ,double–click the wt_inst.exe file.
Follow the instructions on the screen. Write down the directory
where WinTesla is installed on your hard disk.
When installation has finished remove the WinTesla software
disk from your floppy drive.
Insert the Dongle driver diskette into your floppy drive.
Select the floppy drive and:
For Windows 3.1 and 3.11:
Start installation, double–click the dk2wn16.exe file.
For Windows 95 and NT:
Start installation,double–click the dk2wn32.exe file.
Follow the instructions on the screen.
When installation has finished remove the dongle driver
software disk from your floppy drive.
Continue with the following installation.