User Guide

PAMS
Technical Documentation
NSE–5
Service Software Instructions
Page 54
Issue 1 07/99
RX continuous mode channel is activated
- RF Information window is updated
The RX value is always given as default.
Note Function is activated immediately, Apply is not needed.
TX radio button (ALT+T):
When TX is selected, the next functions are made:
- Data transmission is activated
- If operation mode is continuous,
Operation mode is set to burst
- RF Information window is updated
Continuous mode radio button is disabled.
Note Function is activated immediately, Apply is not needed.
Operation Mode group:
Continuous radio button (ALT+C):
When continuous selection is used,
- synthesiser is set to constant frequency
- synthesiser channel number is as given with Continuous Mode Chan-
nel selection
- transmitter power is not connected
- if Active Unit is RX, AGC is controlled
Note Function is activated immediately, Apply is not needed.
Burst radio button (ALT+B):
When burst selection is used,
- synthesiser is controlled by using receiving/transmission/measuring
synthesiser control sequence
- synthesiser channel numbers are as given with Channel/Monitoring
Channel selections
- if Active Unit is TX, data (selected with TX Data Type) is sent and the
TX power is connected
Note! Function is activated immediately, Apply is not needed.