User Guide

PAMS
Technical Documentation
NSE–5
Service Software Instructions
Page 47
Issue 1 07/99
Phase Difference scroll bar (ALT+P):
When this selection is made user can increase or decrease the phase
difference within 0.5° steps. The current phase difference is shown on
the tuning window with numbers and bar figure. The value range is
–85...90.
Save button (ENTER):
Dialog is closed and tuning is saved to phone.
Cancel button (ESC):
Dialog is closed and tuning is not saved to phone.
After each value change the new value is sent to the phone.
The next automatic selections are made, and the RF Information window
is updated when the TX I/Q tuning function is ended:
- Band= GSM
- Active Unit= RX
- TX Power level= (Off)
- Operation Mode= Burst
Energy Management Calibration... command
This command opens the Energy Management Calibration dialog box: