User Guide

PAMS
Technical Documentation
NSE–5
Service Software Instructions
Page 31
Issue 1 07/99
The After Sales SW sets automatically the MS state to local mode when
needed. If phone identification view is open, window will be automatically
updated. Also if RF Information Window is open it will be updated to quick
info view.
When the user selects any of the following items, the MS–state is
automatically set to normal:
Testing Vibrator
Dealer Set UI/DEV Default Values
Local Mode
Activation Status Bar Text
Alt, P, L Initialising local mode....;
Shift+F5
Selection will change the MS–state to local. When the user selects any of
the following items the MS–state is automatically set to local:
Tuning RX Calibration
Tuning Tx Power
Tuning Tx I/Q
Tuning Energy Management Calibration
Testing RF Controls
Testing RSSI Reading
Testing Self Tests
Testing Audio Internal
Testing Vibrator
Testing Call Simulation
Testing Noise Sensitivity
Software Warranty State
Dealer User Settings
Dealer Short Code Memory
Dealer Restore User Defaults
The After Sales SW sets automatically the MS state to local mode when
needed.
Also if quick info view is open it will be updated to RF Information view.