User Guide

CCS Technical Documentation 7 - Troubleshooting Instructions
RH-26
Issue 1 02/04 ©Nokia Corporation Page 23
Synthesizer
General instructions for synthesizer troubleshooting
1 Connect test jig to computer with DAU-9S cable or to FPS-8 Flash Prommer with
XCS-4 modular cable.
Make sure that you have PKD-1 dongle connected to computers parallel port.
2 Connect DC power supply or FPS-8 to module test jig with FLC-2 cable.
3 Set the DC supply voltage to 4.2V.
4 Set the phone module to test jig and start Phoenix service software.
5 To initialize connection to the phone (use FBUS driver when using DAU-9S and
COMBOX driver when using FPS-8):
• From the File menu, choose Product.
• Select RH-26.
6 From the toolbar, set operating mode to "Local".
7 To activate the RF controls window:
• From the Testing menu, choose RF Controls.
8 In the RF Controls window:
• Select band "GSM850", "GSM 1800" or “GSM 1900” (Default = "GSM850")
• Set Active unit to "Rx" (Default = "Rx")
• Set Operation mode to "Continuous" (Default = "Burst")
• Set Rx/Tx channel to 37 on GSM850 band, 700 on GSM1800 band or 661 on
GSM1900 band (Defaults)