User Guide

RH-26
7 - Troubleshooting Instructions CCS Technical Documentation
Page 14 ©Nokia Corporation Issue 1 02/04
Additional Information for EDGE troubleshooting
Note! EDGE mode troubleshooting differs slightly from basic GSM troubleshooting.
1 Establish connection to the phone normally (see GSM850/GSM1800/GSM1900
troubleshooting instructions).
2 From the File menu, choose Product.
3 Select RH-26.
4 From the toolbar, set operating mode to “Local”.
5 To activate the RF Controls window:
• From the Testing menu, choose RF Controls.
6 In the RF Controls window:
• Select Band “GSM850”, “GSM1800” or “GSM1900” (Default = “GSM850”).
• Set Active unit to “Tx” (Default “Rx”).
• Set Edge “On” (Default = “Off”).
• Set Operation mode to “Burst” (Default = “Burst”).
• Set Tx data type to “Alternate PN9” (Default = “All 1”).
• Set Rx/Tx channel to 37 on GSM850, 700 on GSM1800 or 661 on GSM1900
(Defaults).
• Set Power level to 8 on GSM850 (Default = “19”) or to 2 on GSM1800 and
GSM1900 (Default = “15”).
NOTE! For GSM850 EDGE power levels 5, 6 and 7 are not in use and for GSM1800 and GSM1900
EDGE power levels 0 and 1 are not in use.