User Guide

CCS Technical Documentation 6 - Disassembly and Assembly Instructions
Company confidential RH-26
Issue 1 02/04 ©Nokia Corporation. Page 11
Changing the Dome Sheet
(1)
To loosen the corner of the keydome, use SRT-6. Be
careful not to damage the LEDs. The B-cover or sol-
dering jig can be used to fix the power board.
(2)
To avoid remains of glue, tear off the keydome in
diagonal direction. Check pads for cleanness.
(3)
Place a new keydome on to the assembly jig. Note the
guiding pins.
(4)
Remove the protection foil. Do not touch the adhesive
side of the keydome.
(5)
Place the power board on the jig. Note the guiding
pins.
(6)
This is the correct position of the assembly jig.