User Guide

i If the values are OK, click Yes to save the values.

8. Close the tuning window.

Alternative steps

• From the dropdown menus, set "Operating mode" to Local and "System mode" to WCDMA.

• From the Tuning menu, choose WCDMA -> Rx AGC Alignment.

• Click Start.

• Check the “Tune Rx Band Response” check box and click Tune.

• Setup the signal generator according to the values in the pop-up window:

Frequency list: 2113.4 MHz, 2141 MHz and 2166.6 MHz

Dwell time: 2 ms

Sweep control: Automatic continuous sweep

Level: –51 dBm + cable and adapter attenuations

Modulation: FM

Deviation: 500 kHz

Modulation frequency: 50 kHz

• Click OK.

• Check that the “Rx chain” , “Low freq.” and “High freq.” values in the Tuning Results window are within the

limits presented in the table below.

RM-1

RF Troubleshooting and Manual Tuning Guide Nokia Customer Care

Issue 1 Company Confidential Page 7–45