Customer Care Solutions RM-37 Series Transceivers 5-Disassembly Instructions Issue 1 04/2004 ©Nokia Corporation.
RM-37 5-Disassembly Instructions Company confidential CCS Technical Documentation Table of Contents Page No Disassembly Procedure (see also video clips) ............................................................... 3 Assembly Instructions for Camera Module ................................................................... 6 Page 2 ©Nokia Corporation.
CCS Technical Documentation Company confidential RM-37 5-Disassembly Instructions Disassembly Instructions (see also video clips) Push the Release Button to the left before pulling up the B-Cover. Unlock the top guidance to remove the A-Cover. Unscrew the six TORX PLUS® size 6 screws, using the order shown. For assembly, the reverse order and a torque of 22Ncm have to be used. Take the modules from C-Cover and unplug the display connector by pulling the modules apart carefully.
RM-37 5-Disassembly Instructions Company confidential CCS Technical Documentation Open the snaps with SRT-6 on both sides of the Display Shield. The Display Shield is attached with hooks at its bottom side. Take a clean cloth and press the LCD from the LCD Frame. Bend the frame a bit, shift the UI Module to the right and then pull it up. Remove UI-Module. To remove the DC Jack, place tweezers between the spring contacts and under the jack.
Company confidential RM-37 5-Disassembly Instructions CCS Technical Documentation The Power Key has to be unlocked on the lower side first. Unlock Antenna on both sides with SRT-6. Antenna Pogo Pins can be removed by pushing with Torx driver through the C-Cover. If there is a need to change the Release Button, also SRT-6 can be used. Remove Connector Shield when cleaning contacts or changing Camera Module. Camera Module is attached with four snaps into its guidance.
RM-37 5-Disassembly Instructions Company confidential CCS Technical Documentation Assembly Instructions for Camera Module Shift the SRT-10 into the camera groove. Take the Camera Module carefully and note the marking. Place Camera Module into its guidance. It is very important to take correct position of the Camera Module to avoid destruction of this device. Use SRT-10 to lock Camera Module into its guidance. Note locking order. Put the Connector Shield on the camera guidance and press it down.
