User Guide

CCS Technical Documentation Disassembly
RH-25
Issue 1 10/2003 ©Nokia Corporation Confidential Page 3
Remove the modules from the C-cover and unplug the
display connector by pulling the modules apart care-
fully.
Microphone may be removed; however, it must be
replaced with a new part! When assembling new part,
pay special attention not to touch spring contacts as
they are easily damaged.
Open the snaps on both sides of display shield (two on
each side).
The Display Shield is hooked at the bottom edge.
Press the LCD off of the LCD Frame. Use a clean cloth
as shown above.
Bend the frame a bit, shift the UI Board Module to the
right and then pull it up.
Step-by-Step Disassembly Instructions (Model 6560)