CCS Technical Documentation RH-25 Series Transceivers Disassembly Issue 1 10/2003 Confidential ©Nokia Corporation
RH-25 Disassembly CCS Technical Documentation ESD Protection Disassembly Instructions Step-by-Step Disassembly Instructions (Model 6560) Push the Release Button to the left before pulling up the B-Cover. Remove the battery. Unlock the top guidance to remove the A-Cover. Unscrew the six T6 screws, using the shown order. For assembly, the reverse order (i.e., labeled number 6 is first screw for assembly) and a torque of 17Ncm must be used.
RH-25 Disassembly CCS Technical Documentation Step-by-Step Disassembly Instructions (Model 6560) Remove the modules from the C-cover and unplug the display connector by pulling the modules apart carefully. Microphone may be removed; however, it must be replaced with a new part! When assembling new part, pay special attention not to touch spring contacts as they are easily damaged. Open the snaps on both sides of display shield (two on each side). The Display Shield is hooked at the bottom edge.
RH-25 Disassembly CCS Technical Documentation Step-by-Step Disassembly Instructions (Model 6560) To remove the DC Jack, insert tweezers between the spring contacts and under the jack. You will need to use some force to pull the jack upward. Battery connector may be removed with a small pair of needle nose pliers. Grasp connector between contacts and pull straight up. If contacts are bent even slightly during this procedure, replace with new part.
RH-25 Disassembly CCS Technical Documentation Step-by-Step Disassembly Instructions (Model 6560) The release button may be removed with fingers or with black stick. Once removed, a new button must be used as the retaining clips will have been weakened. Assembly Instructions Use the Disassembly Instructions in the reverse order to reassemble the handset.
RH-25 Disassembly Page 6 CCS Technical Documentation ©Nokia Corporation Confidential Issue 1 10/2003
