User Guide

NPM–9
CARK132
PAMS Technical Documentation
Page 5
Issue 1 02/2002
 Nokia Corporation
Component Parts
Advanced Active Car Holder MCC-5
The holder for the mobile phone is attached to the vehicle’s interior always in an up-
ward position, shown in Fig. 2 below, using the swivel mount HHS-9. The mounting
is secured with a screw (included with HHS-9). The screw recess is covered with the
NOKIA logo plate.
The cable with the plug-in connector from MCC-5 connects to the PHONE socket in
HFU-5 (The other cable from MCC-5 connects to the external antenna.)
Swivel Mount HHS-9 and Mounting Plate MKU-1
HHS-9 is a swivel mount which offers two installation methods for the holder MCC-5.
Either use all components to make a swivel mount, or use the flat mounting plate for
a fixed position.
For an exploded view, see Figure 2.
FIG.2
Mounting plate MKU–1
The handsfree unit HFU-5 is attached to the vehicle interior using the mounting plate
MKU–1. The mounting is secured with a screw (included with MKU–1).
Advanced HF Unit HFU-5
The handsfree unit HFU-5 enables the phone to operate in handsfree mode and it is
attached to the vehicle interior using the mounting plate MKU-1. The mounting is se-
cured with a screw (included with MKU-1).
Power Cable PCH-4J
The power cable connects to the DC socket in HFU-5 and to the vehicle’s power
supply. See section ”Installation” for more information.
HF Microphone HFM-8
The HF microphone connects to the MIC socket in HFU-5. Twist the plug clockwise
to lock firmly in place.
HF Speaker HFS-12
The HF speaker connects to the SPEAKER socket in HFU-5. Twist the plug clock-
wise to lock firmly in place.
Antenna Set NMT/GSM 900/1800 AMD–2 (not included)
The external antenna AMD–2 is recommended for the car kit. It connects to MCC-5.
For additional information please refer to documentation supplied with the antenna.