User Guide

NPW-2NX
9. Troubleshooting
PAMS Technical Documentation
3DJH 1RNLD&RUSRUDWLRQ ,VVXH
 3RZHUNH\SUHVVHG
•
After 20ms, UEM enters RESET MODE if VBAT>Vmstr+
•
VFLASH1, Vana, Vcore, Vio, and VR3 goes high
•
VCTCXO enabled by VR3 -> RFClk 19.44 MHz running
 3XU[UHOHDVHG
•
Purx released by UEM, UEMINT goes high for 100 ms, SleepX
goes high, and SleepClk (32 KHz) starts running.
 6RIWZDUHUXQQLQJ
•
Default value for Vcore is 1.5 volts and, if software is running, Vcore
will rise to 1.8 volts
•
Cbus (1.08MHz) and Dbus clocks start running
3KRQHGRHVQRWVWDUWXSQRUPDOO\RUGRHVQRWVWD\RQ
7KHHDVLHVWZD\WRFKHFNLIWKHVRIWZDUHLVUXQQLQJZKHQWKHSKRQHWDNHVDQDEQRUPDO
DPRXQWRIFXUUHQWLVWRPHDVXUHWKHFEXVFONDQG9FRUH
7KH'EXVFORFNSURJUDPPDEOH0+]LVQRWDXWRPDWLFDOO\YLVLEOHLQWKHWHVWDQGORFDO
PRGHV