User Guide

PAMS Technical Documentation
9. Troubleshooting
NPW-2NX
,VVXH 1RNLD&RUSRUDWLRQ 3DJH
 7KH)/$6+3URJUDPLQFOXGHVDSDFNDJHRI0&8DQG'63VRIWZDUHDQGDOOGHIDXOW
SDUDPHWHUVIRUWKHSKRQH7KHWXQLQJYDOXHVZLOOEHDGGHGUHZULWWHQGXULQJWKH
)ODVK$OLJQPHQWSKDVH
)ODVKSURJUDPPLQJHUURUFRGHV
7KHYDULRXVHUURUFRGHVFDQEHVHHQIURPWKH)36)ODVKLQ3KRHQL[
7KHXQGHUOLQHGWH[WLQWKHIROORZLQJWDEOHPHDQVWKDWWKHLWHPXQGHUFRQVLGHUDWLRQLV
EHLQJXVHGIRUWKHILUVWWLPHLQWKHIODVKLQJVHTXHQFH
Error
Description
Not working properly
C101
"The Phone does not set FbusTx line high after the startup."
Vflash1
VBatt
BSI and FbusRX from prommer to UEM.
FbusTx from UPP->UEM->Prommer(SA0)
C102
"The Phone does not set FbusTx line low after the line has
been high. The Prommer generates this error also when the
Phone is not connected to the Prommer."
PURX(also to Safari)
VR3
Rfclock(VCTCXO->Safari->UPP)
Mbus from Prommer->UEM-
>UPP(MbusRx)(SA0)
FbusTx from UPP->UEM->Prommer
(SA1)
BSI and FbusRX from prommer to UEM.
C103
"Boot serial line fail."
Mbus from Prommer->UEM-
>UPP(MbusRx)
(SA1)
FbusRx from Prommer->
UEM->UPP
FbusTx from UPP->UEM->Prommer
C104
"MCU ID message sending failed in the Phone."
FbusTx from UPP->UEM->Prommer
C105
"The Phone has not received Secondary boot codes length
bytes correctly."
Mbus from Prommer->UEM-
>UPP(MbusRx)
FbusRx from Prommer->UEM->UPP
FbusTx from UPP->UEM->Prommer
C106
"The Phone has not received Secondary code bytes correctly."
Mbus from Prommer->UEM-
>UPP(MbusRx)
FbusRx from Prommer->UEM->UPP
FbusTx from UPP->UEM->Prommer
C107
"The Phone MCU can not start Secondary code correctly."
UPP
C586
"The erasing status response from the Phone informs about
fail."
Flash
C686
"The programming status response from the Phone informs
about fail."
Flash
Cx81
"The Prommer has detected a checksum error in the message,
which it has received from the Phone."
FbusTx from UPP->UEM->Prommer
Cx82
"The Prommer has detected a wrong ID byte in the message,
which it has received from the Phone."
FbusTx from UPP->UEM->Prommer