User Guide

ManualsBrandsNokia ManualsCell Phone6310

Programmes After Market Service

NPE-4 Series Cellular Phones

Original ãNokia Corporation. Page 7-1

7 - Disassembly Instructions

Summary of content (8 pages)

PAGE 1
Programmes After Market Service NPE-4 Series Cellular Phones 7 - Disassembly Instructions Original ãNokia Corporation.
PAGE 2
NPE-4 7 - Disassembly Instructions PAMS Technical Documentation Table of Contents Description Page No. Disassembly instructions ............................................................................................................... 3 Remove battery ......................................................................................................................... 3 Remove dustcap .............................................................................................................
PAGE 3
NPE-4 7 - Disassembly Instructions PAMS Technical Documentation Disassembly Instructions 1. Remove Battery 1 Push button. 2 Slide battery towards system connector and remove. 1 2 2. Remove Dustcap 1 Original Remove dustcap. ãNokia Corporation.
PAGE 4
NPE-4 7 - Disassembly Instructions PAMS Technical Documentation 3. Remove 4 Screws 1 Remove 4 screws(Torx # 6) 4. Remove B-cover Page 7-4 1 Lift B-cover at system connector - be aware of the tight snaps each side of the type label. 2 Twist the B-cover slightly both ways until it releases. 3 Lift B-cover until 3 top snaps disengage. ãNokia Mobile Phones Ltd.
PAGE 5
PAMS Technical Documentation NPE-4 7 - Disassembly Instructions 5. Remove Antenna Original 1 Remove the antenna screw (Torx # 6). 2 Lift up antenna from the body. ãNokia Corporation.
PAGE 6
NPE-4 7 - Disassembly Instructions PAMS Technical Documentation 7. Remove PWB 1 Carefully lift up the PWB. 8. Remove Keymat, Speaker and Buzzer. 1 Carefully lift out the Keymat. 2 Remove the Speaker and the Buzzer using a straight bladed screwdriver. NOTE: Avoid touching Speaker and Buzzer Springs and Speaker Membrane. Page 7-6 ãNokia Mobile Phones Ltd.
PAGE 7
NPE-4 7 - Disassembly Instructions PAMS Technical Documentation 9. Remove the Lightguide 1 Carefully bend the two plastic bottom snaps out (1). 2 Bend out the two top plastic snaps (2). 3 Lift out the Lightguide. 2 1 10. Removing the Microphone 1 Remove the Microphone by lifting the tape (1). 1 IMPORTANT NOTES 1. Never re-use removed Shield Can Lids - a new lid must be fitted in order to comply with type approval requirements. 2.
PAGE 8
NPE-4 7 - Disassembly Instructions PAMS Technical Documentation This page intentionally left blank Page 7-8 ãNokia Mobile Phones Ltd.