User Guide

Nokia Customer Care Baseband Description and Troubleshooting
6255/6255i6256/6256i (RM-19)
Issue 2 05/2005 ©2005 Nokia Corporation Company Confidential Page 73
Camera
Bluetooth
See the RF Troubleshooting chapter for Bluetooth troubleshooting information. When
the flash D450 or UEME have been replaced the ESN has to be reprogrammed. This
automatically includes reprogramming the BT address.
SIM
The hardware of the SIM interface from the UEME (D2200) to the SIM connector (X2700)
can be tested without a SIM card. When the power is switched on, the mobile terminal
checks for a 1.8V SIM card and then a 3V SIM card. The mobile terminal attempts this
four times, whereafter it displays "Insert SIM card".
Camera
faults
Power on the phone
and turn camera on
by Phoenix or UI
menu
Make sure soldering
on D6600 and X6600
is OK and check
PUSL(1) on pin 19 of
X2451. Is it high?
Check VDIG voltage
at C6615
Check V2.8 voltage
at C6607
NO
Check D2200 and
replace it when
D2200 stays low
NO
Replace N6601
regulator
Replace N6600 if
there is no output
from the regulator
Check D2800 and
replace it if this
GenIO(27) is low all
the time
YES
YES
NO
NO
Check whether CE is
high
YES
NO
Try test again
YES