User Guide

Nokia Customer Care Baseband Description and Troubleshooting

6255/6255i6256/6256i (RM-19)

Figure 12: Flashing, continued 2

Flash Programming Error Codes

The following characteristics apply to the information in Table 4.

• Error codes can be seen from the test results or from Phoenix's flash-tool.

• Underlined information means that the connection under consideration is being

used for the first time.

Table 4: Flash Programming Error Codes

Error Description Not Working Properly

C101 "The Phone does not set FbusTx line high after

the startup."

Vflash1

VBatt

BSI and FbusRX from prommer to UEME.

FbusTx from UPP->UEME->Prommer(SA0)

C102 "The Phone does not set FbusTx line low after

the line has been high. The Prommer generates

this error also when the Phone is not con-

nected to the Prommer."

PURX(also to Safari)

VR3

Rfclock(VCTCXO->Safari->UPP)

Mbus from Prommer->UEME-

>UPP(MbusRx)(SA0)

FbusTx from UPP->UEME->Prommer(SA1)

BSI and FbusRX from prommer to UEME.

CH1 = PURX

CH2 = MBUS

CH3 = FBUSTX

CH4 = FBUSRX

Measure points

Production test pattern

(J396)

FLASH_3

Data transfer has

started (Fbus_Rx)