User Guide

6255/6255i/6256/6256i (RM-19)

Service Software Instructions Nokia Customer Care

Hardware Requirements for Using Phoenix

Installing Phoenix

Before installing the software, verify the following:

• The dongle is attached to the parallel port for PKD version dongles, or an FLS-4

version dongle is attached on either the parallel port or the USB port (if the

computer supports USB).

• Ensure that if the computer supports administrator rights (typically on Windows

NT and Windows 2000 installations) that access is enabled for the user

performing the Phoenix installation.

• If a previous version of Phoenix has been installed, it may be necessary to first

properly remove that program prior to installing the new version. If installation is

performed, be sure to reboot the computer prior to continuing. See the

"Uninstalling Phoenix" section for instructions on how to uninstall.

Installation Instructions

Use the following steps to install Phoenix:

1. Insert the CD into the computer.

2. Navigate to the CD-ROM drive, and double-click the Phoenix software package.

3. Follow the on-screen prompts.

4. Reboot the computer when the installation is complete.

Table 1: Minimum Hardware Requirements

Hardware Minimum Value

Processor 233 MHz

RAM1 64 MB

Disk space needed 50-100 MB

Table 2: Supported Operating System Information

Operating System Notes

Windows 98 SE only

Windows NT 4.0 No USB support

Windows 2000 Professional version