User Guide

NHM-3
Service Software Instructions PAMS Technical Documentation
3DJH 1RNLD0RELOH3KRQHV/WG 2ULJLQDO
3RZHUGLVWULEXWLRQZLWKRQH$&/DQGRQH$&+FKDUJHU
FLA-7 powered by ACL-3 charger
TDF-4 powered by ACH-6 Charger
FPS-4 powered by SCF-7 cable from FLA-7 "Out FPS-4" connector
Use this power distribution setup if you have FPS-4 sales pack with ACL-3 charger.
NOTE: If you don’t have ACL-3, please use power distribution setup with AXD-1 and
ACH-6 described below.
3RZHUGLVWULEXWLRQZLWKWZR$;'FDEOHVDQGWZR$&+FKDUJHUV
FLA-7 powered by AXD-1 cable from TDF-4 "Power Out" connector (It is also pos
sible to power FLA-7 with AXD-1 and separate ACH-6).
TDF-4 powered by ACH-6 Charger.
FPS-4 powered by AXD-1 DC cable and ACH-6 Charger
NOTE: Do not use SCF-7 cable to power FLA-7 and FPS-4 from one ACH-6 charger
like it was done with ACL-3 !