User Guide
Table Of Contents
- 02 Parts List and Component Layouts
- 08 Schematics
- Top Level, 1maa_02, v.0 ed. 40
- RF Top Level,1maa_02, v. 0.0 ed. 67
- RX Front End and Antenna Switch, 1maa_02, v. 0.0 ed. 79
- HELGA, 1maa_02, ed. 98
- RF9204 Power Amplifier and Power Detection, 1maa_02, v. 0.2 ed. 65
- BR4.5 Top Level, 1maa_02, v. 6.1 ed. 43
- BR45 Audio, 1maa_02, v. 1.6 ed. 190
- Mirage 2 VGA Camera, 1maa_02, v. 1.1 ed. 206
- Citizen IR Module 1.8V, 1maa_02, v. 6.1.8 ed. 56
- IR Resistor 1210, 1maa_02, v. 0 ed. 6
- Key UI, 1maa_02, v. 1 ed. 350
- Flash Memory 128 Mbit, 1maa_02, v. 2.0 ed. 81
- Discrete Capacitors for two Memories without VFlash1, 1maa_02, v. 1.3 ed. 14
- Flash Memory 64 Mbit NAND, 1maa_02, v. 2.0 ed. 68
- MMC Interface, 1maa_02, v. 2.1 ed. 80
- UEME Power Management - Dual 1 uF 6V3 Capacitors, 1maa_02, v. 1.0 ed. 321
- UEME ADC Filter Block - BSI, BTEMP and Active PATEMP, 1maa_02, v. 1.0
- DC_DC for TIKU and VIO, 1maa_02, v. 1.7 ed. 79
- Light Filtering for Projects using 1uF Caps, 1maa_02, v. 1.0
- Tiku Systems, 1maa_02, v. 1.0
- 32KHz Crystal- Micro Crystal CC4VT2, 1maa_02, v. 0 ed. 8
- GSM RF - Baseband Interface, 1maa_02, v. 1.3 ed. 65
- 64Mbit 2V8 SDRAM Memory, 1maa_02, v. 1.0 ed. 68
- SIM Reader, 1maa_02, v. 1.3 ed. 67
- System Connector, 1maa_02, v. 0.0 ed. 204
- Current Measure, 1maa_02, v. 0 ed. 19
- 5 pin Test Pattern, 1maa_02, v. 2.0 ed. 53
- TIKUedge Implementation (GSM), 1maa_02, ed. 135
- Discrete Decoupling Capacitors for Tiku, 1maa_02, v. 0 ed. 12
- TikuEDGE Bus Conversion Sheet, 1maa_02, v. 1.2 ed. 104
- FM Radio Unit, 1maa_02, v. 1.3 ed. 199
- Differential Stereo, 1maa_02, v. 0.0 ed. 7
- Low Power RF Module, 1maa_02, ed. 148
- GENIO and GPIO Connection Block, 1maa_02, v. 0.0 ed. 42
Nokia Customer Care Schematics RM-72
Issue 1 03/05 Copyright © Nokia 2005. All rights reserved. Page A-15
MMC Interface, 1maa_02, v. 2.1 ed. 80
NOTE: The MMC specification imposes the following impedance limits
Power Mode
1 = Active / 0 = Sleep(3mA MAX)
data
EMIF02-MMC R10=13k (therefore only suitable for command line)
EMIF02-MMC R20=56k (therefore only suitable for data line)
cmd
Not final connector
reserved
command
UEME includes a 13k pullup between GEN28IO2 (command) and VAUX1
so EMIF02-MMC R10 is left unconnected. UEME has no pullup on GEN28IO3 (MMC data)
clk
cmd
data
Command pullup resistance 4.7k to 100k
Data pullup resistance 50k to 100k
ground
+ve supply
clock
ground
clk
GNDGND
EMIF02-MMC R1/R2/R3/R4=47R
data
MMC Card Connections
ON / OFF CONTROL
1 = active / 0 = Shutdown
GND
GND
GND GND
VMMC
R2
R3
R1
X910
1
2
3
4
5
6
7
R10
R20
R4
R910
EMIF04-MMC02F2
VMMC
GND
3
2
0
1
C910
100n
SIM2MMCIF(3:0)