User Guide

CCS Technical Documentation Service Software Instructions
RH-12/RH-28
Issue 1 02/04 Nokia Corporation Page 49
Receiver Tunings
RX channel select filter calibration
Extra equipment / external RF signal is not needed.
Must be done before other RX calibrations.
This function is used to calibrate RX channel select filter in GSM Phones.
Rx Channel select filter is tuned only in one (lowest) band = Single calibration for all
bands.
Select Tuning => Rx Channel select filter calibration.
Press “Tune" to start the tuning.
Values will be saved to the phone when the “Save to Phone” tick box is checked.
If the “Save to Phone” tick box is not checked, the values are not saved to the phone
when you stop the tuning or exit the dialog.
Tuning values should be 0…31.