User Guide

RH-27

Assembly CCS Technical Documentation

11. Put the Speaker into the frame so that the guiding

pin goes into its place.

12. Put the Microphone into the frame.

Note! Do not touch the spring contacts.

13. Place the UI Module and the engine together by

closing the Display connector.

14. Put the unit into the C-cover. 15. Tighten the six screws in the order indicated above.

Note! Set 20Ncm/650rpm to your Torque driver before

tightening.

16. Place the B-cover into its place. Make sure the

snaps on both sides are locked to the module.

17. Place the Keymat into its place.

Step-by-Step Assembly Instructions (Model 6225)