CCS Technical Documentation RH-27 Series Transceivers Assembly Issue 1 11/2003 Confidential ©2003 Nokia Corporation
RH-27 Assembly CCS Technical Documentation Step-by-Step Assembly Instructions Alway use ESD protection Assembly Instructions Step-by-Step Assembly Instructions (Model 6225) 1. Press the Release Key down into its correct position. 2. Put the Release Spring into its place. 3. Put the DC Jack into its place. 4. Put the Vibra into its place. Note! Avoid touching the spring contacts.
RH-27 Assembly CCS Technical Documentation Step-by-Step Assembly Instructions (Model 6225) 5. Put the Volume Key into its place. 6. Put the Power Key into its place. 7. Put the Antenna into its place. Note! Do not touch the inside of the Antenna plate. 8. Put the UI Board into its place. 9. Place the LCD into the UI frame. Note! Do not press the LCD as it may get damaged. 10. Fit the Display Shield into its place. Make sure the shield is properly locked on both sides to the frame.
RH-27 Assembly CCS Technical Documentation Step-by-Step Assembly Instructions (Model 6225) 11. Put the Speaker into the frame so that the guiding pin goes into its place. 12. Put the Microphone into the frame. Note! Do not touch the spring contacts. 13. Place the UI Module and the engine together by closing the Display connector. 1. 2. 3. 4. 5. 6. 14. Put the unit into the C-cover. 15. Tighten the six screws in the order indicated above.
RH-27 Assembly CCS Technical Documentation Step-by-Step Assembly Instructions (Model 6225) 18. Place the A-cover into its place. 19. Slide the Battery cover into its place until the Release Key locks it.
RH-27 Assembly Page 6 CCS Technical Documentation ©2003 Nokia Corporation Confidential Issue 1 11/2003
