User Guide
Table Of Contents
- Service Software Instructions
- Quick Guide for Phoenix Service SW Installation
- Phoenix Service SW
- Data Package for Phoenix (Product Specific)
- How to Update Flash Support Files for FPS-8* and FLS-4S*
- FPS-8 Activation and Deactivation
- JBV-1 Docking Station SW
- Receiver tuning: Quick Guide for Tuning With Phoenix
- Service Tool Concept for RF Tuning Operations
- Autotuning
- Receiver Manual Tuning
- Transmitter Manual Tuning
- Service Tool Concept For Baseband Tuning Operations
- Baseband Tuning operations
- Flashing Setup Instructions
- BACK TO MAIN PAGE
NPL-3
CCS Technical Documentation
Page 70 Copyright ãNokia. All rights reserved. Issue 1 3/03
Adjust spectrum analyzer accordingly.
Press “OK” and start tuning.
Tuning is done by setting each of the sliders to desired value.
The order of tuning should be the same as the order of the sliders, that is, the Tx I DC
Offset is tuned first and Phase difference is tuned last.
Use <= , =>, PgUp or PgDn keys.
Tune LO leakage to minimum with TXI/TXQ DC Offset control (f0 on spectrum analyzer
screen).
Tune unwanted sideband to minimum using Amplitude/Phase difference controls (f0 +