User Guide
Table Of Contents
- Service Software Instructions
- Quick Guide for Phoenix Service SW Installation
- Phoenix Service SW
- Data Package for Phoenix (Product Specific)
- How to Update Flash Support Files for FPS-8* and FLS-4S*
- FPS-8 Activation and Deactivation
- JBV-1 Docking Station SW
- Receiver tuning: Quick Guide for Tuning With Phoenix
- Service Tool Concept for RF Tuning Operations
- Autotuning
- Receiver Manual Tuning
- Transmitter Manual Tuning
- Service Tool Concept For Baseband Tuning Operations
- Baseband Tuning operations
- Flashing Setup Instructions
- BACK TO MAIN PAGE
NPL-3
CCS Technical Documentation
Page 44 Copyright ãNokia. All rights reserved. Issue 1 3/03
RX Calibration
RF generator needed.
This tuning performs RX Calibration.
Must be done separately on every band!
Calibration is automatically performed at GSM850, then at GSM1800 and finally at
GSM1900 band. If tuning is successful, it continues in the next band.
AFC tuning is done while GSM850 band RX Calibration is performed.
Remember to take jig and cable attenuations into account!
Select Tuning => Rx calibration
Press “Calibrate"´to start tuning.
Set RF generator to required GSM850 frequency => OK