User Guide
Table Of Contents
- Service Software Instructions
- Quick Guide for Phoenix Service SW Installation
- Phoenix Service SW
- Data Package for Phoenix (Product Specific)
- How to Update Flash Support Files for FPS-8* and FLS-4S*
- FPS-8 Activation and Deactivation
- JBV-1 Docking Station SW
- Receiver tuning: Quick Guide for Tuning With Phoenix
- Service Tool Concept for RF Tuning Operations
- Autotuning
- Receiver Manual Tuning
- Transmitter Manual Tuning
- Service Tool Concept For Baseband Tuning Operations
- Baseband Tuning operations
- Flashing Setup Instructions
- BACK TO MAIN PAGE
NPL-3
CCS Technical Documentation
Page 42 Copyright ãNokia. All rights reserved. Issue 1 3/03
Figure 7: Setup environment
GPIB addresses are not defined. Component finds the addresses and uses them automat-
ically.
If several TX tuning devices are connected, this component uses Agilent (VSA or PSA). In
RX side, Agilent has highest priority.
Protection
Components are protected by PKD-1CS, PKD-1NS, PKD-1 and PKD-1P dongles using
standard TSS protection procedure. Autotuning itself is possible with all these dongles
but with PKD-1P and PKD-1 dongles user is not able to set the loss.
Receiver Manual Tuning
RX Channel Select Filter Calibration
Extra equipment / external RF signal not needed.
Must be done before other RX calibrations.
This function is used to calibrate RX channel select filter in GSM Phones.
Rx Channel select filter is tuned only in one band = Single calibration for both bands.
Select Tuning => Rx Channel select filter calibration.
“Save to Phone “ is checked by default