User Guide
Table Of Contents
- Service Software Instructions
- Quick Guide for Phoenix Service SW Installation
- Phoenix Service SW
- Data Package for Phoenix (Product Specific)
- How to Update Flash Support Files for FPS-8* and FLS-4S*
- FPS-8 Activation and Deactivation
- JBV-1 Docking Station SW
- Receiver tuning: Quick Guide for Tuning With Phoenix
- Service Tool Concept for RF Tuning Operations
- Autotuning
- Receiver Manual Tuning
- Transmitter Manual Tuning
- Service Tool Concept For Baseband Tuning Operations
- Baseband Tuning operations
- Flashing Setup Instructions
- BACK TO MAIN PAGE
CCS Technical Documentation
NPL-3
Issue 1 3/03 Copyright ãNokia. All rights reserved.. Page 39
Autotuning
Autotune feature is designed to align product’s RF part easier and faster. By this auto-
tune component the product is tuned automatically. The user only needs to press ‘Tune’
and the product’s RF is tuned and results are shown to the user. Component controls all
the needed RF equipment (RF generator and TX measuring device) except voltage sup-
plier.
NOTE! Automatic tuning is ALWAYS the primary tuning mode. Manual tuning is not recommended.
Following diagram describes how the Autotune component is located in the TSS archi-
tecture:
Figure 2: Autotune component in TSS architecture
Autotune is a pair of two different components. One is User Interface and the other is
FunctioNal. UI does not contain any functionality. MTI takes care of phonet messages.
The Autotune component can be found under Tuning menu:
Figure 3: Autotune menu in Phoenix
6Service SW CD-ROM
Item: Service accessory: Type: Product code:
Autotune UI
GPIB Equipment
Autotune FN
MT
I
Manual tune FNs
GPIB FN
Phone