User Guide

PAMS
Technical Documentation
NME–3
Service Software Instructions
Page 45
Issue 1 10/99
– not pressed –> button is not active
– pressed –> button is active
– not released , the key press is active for more than 2 seconds, –> button is
red.
– if the key is released afterwards, this key enters the status not pressed again,
to force a new test of this key.
When all keys are pressed and the test is pass, the dialog box closes
automatically afterwards.
Cancel button:
Closes the dialog and finishes the keypad test mode.
Pressing of the Power button can not be detected from HCI and WinTesla
test program.
Light Test
Activation Status Bar Text Menu
ALT+E, I Open Light Test dialog. HS alone
ALT+E, H, I “ RU & HS
This test is used to verify the LED Light of the HS.
The LCD and Keypad light can be switched and dimmed separately.
LCD Light – Box :
1. Light off
The LCD light is switched off, by activating this Radio button.
2. Light 75%
The LCD light is dimmed to 75%, by activating this Radio button.
3. Light 100%
The LCD light is dimmed to 100%, by activating this Radio button.