User Guide

PAMS
Technical Documentation
NME–3
Service Software Instructions
Page 36
Issue 1 10/99
Call Simulation... command
Activation Status Bar Text
Alt, E,C Open Call Simulation dialog box
Command is used for making call simulation. Function opens Call Simulation dialog.
Dialog mode: modal
Call Simulation dialog has following items:
TX Power Level edit box (ALT+T):
All power levels can be selected. This updates same parameter as TX Power Level in
the RF Controls dialog. Note that TEST value cannot be selected. If TEST value was in
use when Call simulation menu selected, power level is changed to smallest value.
Channel edit box (ALT+C):
This tells the normal operating RF channel number. Normal GSM channel numbers can
be selected. Same channel is used both for transmission and receiving. This updates
same parameter as Channel in the RF–Controls dialog.
Channel 1
,2,3,4,5,6 edit box (ALT+1,2,...):
Channels for monitoring are specified with these six selections. All GSM channel num-
bers can be used. If more than one selection has same number, the monitoring channel
list (neighbour list) will have less than 6 selected channels. The minimum number of
monitoring channels is one (all channels have same value). The monitoring channel
can also have same value as normal operating channel.
The first monitoring channel updates same parameter as Monitoring Channel in the
RF–Controls dialog.
Apply button (ALT+A):
Validates and sends entered data to ME.
Set Defaults button (ALT+S):
Sets current values as default Call Simulation values.
Get Defaults button (ALT+G):
Gets default Call Simulation values as current values.