User Guide

PAMS
Technical Documentation
NME–3
Service Software Instructions
Page 33
Issue 1 10/99
Note power–off test have no values, because if test has been passed, power has been
turned off. If power–off test fails a special error message window is shown. If no
response is received to power off test message in a few seconds, the user is informed by
special info window, where user is asked to turn the power on and then press the return
key.
Note also that power–off test (if passed) turns power off and power should be recon-
nected by using the phones keypad after the successful test. After the power has been
connected to phone, the normal start–up routines are made and the self–test results are
shown in the MCU self–tests menu (i.e. all other than power–up self–tests are in
Not
executed state after the power–up routines).
Run button (ALT+R):
User can select desired test from list and hit Run button. When user selects test to be
run the text
RUNNING... is shown in test state field and test is run. When results are
received the test state field is updated according to the result.
If no response was received in the defined time, a
error message box will be shown and
the test state is changed to
No response . Phone is set to local mode if it is not already
there.
Run A
ll button (ALT+A):
User can run all listed tests. The text
RUNNING... is shown in test state field and test is
run. When results are received the test state field is updated according to the result.
When state field is updated application moves to next test and repeats previous cycle.
Phone is set to local mode if it is not already there.
Supported Self Tests
1 MCU ROM Checksum................
2 MCU RAM Interface...............
3 MCU RAM Component...............
4 MCU EEPROM Interface............
5 MCU EEPROM Component............
6 RTC Battery.....................
7 CCONT Interface.................
8 A/D Converter...................
9 SW Reset........................
A Power Off.......................
B Security Data...................
C EEPROM Tune Checksum............
D PPM Checksum....................
E MCU Download DSP................
F DSP Alive.......................
G COBBA Serial.......................
H COBBA Parallel.....................
I EEPROM Sec Checksum................
J PPM Validity....................
K Warranty State....................