User Guide

PAMS
Technical Documentation
NME–3
Service Software Instructions
Page 18
Issue 1 10/99
Open... command
Activation Status Bar Text
Alt, P, O Force load phone specific functionality
Phone is set to local mode.
I
nitialise... command
Activation Status Bar Text
Alt, P, I
Opens a submenu
N
ormal Mode
Activation Status Bar Text
Alt, P,I, N Initialises phone to normal mode
F5
When normal mode has been activated or program has been started, self–test results
will be asked from MCU. If any fault was found in the tests, an error message is shown. If
normal mode has been set successfully (no self test error has been found), and paging
listening has been started, the used AFC value is requested from MS.
Initialisation routine checks phone’s cellular type and if unsupported phone is detected,
application unloads the DLLs.
The After Sales SW sets automatically the MS state to normal mode when needed.
If phone identification view is open, window will be automatically updated. Also if RF In-
formation Window is open it will be updated to quick info view.
NOTE: When phone is changed to but phone type does not change, user may select
Product/Initialise/Normal Mode instead of Product/New.
Local Mode
Activation Status Bar Text
Alt, P,I, L Initialises phone to local mode
Shift+F5
Selection will change the MS state to
local . When user selects item from Testing or Tun-
ing menus, the After Sales SW software will change automatically the MS state to local.
The After Sales SW sets automatically the MS state to normal mode when needed.
Also if quick info view is open it will be updated to RF Information view.