User Guide

PAMS
Technical Documentation
NME–3
Mechanical Parts Assembly Instructions
Page 5
Issue 1 10/99
A – COVER PRE ASSEMBLY
• Power key (6) to A – cover
(ensure, that both coding pins fit into
the power key)
• Keymat (5) to A – cover
(do not touch contact area)
• Clean contact pads of keymat module with com-
pressed air in the direction of the arrow
6
5
CODING PINS
12
8
FF
PCB SUB ASSEMBLY
• Check the LCD module version (Minna or
Dude)
• Check that there is no rest at the PCB larger
ca.0.2mm
• Fit LCD module (8) to the PCB assy (12)
• Check that all five LCD frame snappers fit
accurately into the PCB
10
2
12
• The curly cord (10) plugs into the PCB assy.
connector (12) – clamp it into place
• LCD protection foil off
• Clean PCB contact pads and LCD with com-
pressed air
• PCB (12) to A – cover (2)
• Strain relief of curly cord (10) to
A – cover, ensure it is fitted the right way
• The curly cord to the right side curls up-
wards
• Clean contact areas compressed air