User Guide

FS-10 product specific

adapter

Flash adapter FS-10 is used for phone testing and flashing. FS-10 is

used with the generic flash adapter base and control Unit CU-4 or

interface adapter.

When flashing or system testing the phone, the adapter is attached to

replace the phone own battery. All functions (as well as the calibration

voltages, current and the protections for over voltages, over current

and voltage polarity), are performed by CU-4.

MJ-111 Module jig

MJ-111 is meant for component level troubleshooting.

PCS-1 Power cable

The PCS-1 power cable (DC) is used with a docking station, a module

jig or a control unit to supply a controlled operating voltage.

PKD-1 SW security device

SW security device is a piece of hardware enabling the use of the

service software when connected to the parallel (LPT) port of the PC.

Without the device, it is not possible to use the service software.

Printer or any such device can be connected to the PC through the

device if needed.

RJ-154 Soldering jig

RJ-154 is used as a soldering jig for the engine module.

RM-198

Nokia Customer Care Service Tools and Service Concepts

Page 4 –8 COMPANY CONFIDENTIAL Issue 1