User Guide

The device Bluetooth is based on BC4 ROM1.0RDL BT chip.

USB

USB (Universal Serial Bus) provides a wired connectivity between host PC and peripheral devices.

USB is a differential serial bus for USB devices. USB controller (RAP) supports USB specification revision 2.0

with full speed USB (12 Mbps). The device is connected to the USB host through the system connector. The

USB bus is hot plugged capable, which means that USB devices may be plugged in/out at any time.

MR sensor

MR sensor is used to monitor the position of the upper block in fold construction.

MR sensor detects the fold position. There is a magnet in fold mechanics under the display module and when

the fold is closed MR sensor is in magnetic field.

Figure 55 MR sensor connection

FM radio

The FM radio circuitry is implemented using a highly integrated radio TEA5760 N1C.

The antenna of the FM Radio is created with the headset. The wires of the headset are used as poles of the

antenna.

Camera

The device uses SMIA65 camera module. SMIA65 is 0.3Mpixel with sensor resolution of 656 x 496.

The camera is powered by using VIO(1.8V) and VAUX(2.78V) voltages from the engine board.

Backup battery

When the main battery is not attached EM ASIC (N2200) goes in backup mode using back-up battery that

supplies voltage to RTC in EM ASIC (N2200).

RM-198

System Module Nokia Customer Care

Issue 1 COMPANY CONFIDENTIAL Page 8 –9