User Guide
Table Of Contents
- 4 - Service Tools
- Service Tools
- List of service tools
- JVB-1 Docking Station with DA-16 Docking Station Adapter
- DA-16 Docking Station Adapter
- SA-25 Antenna Coupler
- SF-17 CCS POS Flash Adapter
- MJ-22 Module Repair Jig
- RJ-66 Soldering Jig
- ST-11 PA Rework Stencil
- Rework procedure
- RJ-46 Antenna Switch Rework Jig
- ST-15 / ST-31 Antenna Switch Solder Paste Stencil
- FPS-8 Flash Prommer
- FPS-10 Flash Prommer
- FPS-11 Multiprommer
- ACF-8 Universal Power Supply
- FLC-2 DC Cable
- AXS-4 Service Cable
- XCS-1 Service Cable
- SW Security Device PKD-1
- FLS-4S POS (Point Of Sale) Flash Device (Sales Pack)
- PCS-1 Power Cable
- CA-41 PS
- XRF-1 RF Cable
- DAU-9S MBUS Cable
- XCS-4 Modular Cable
- CA-5S Service Battery Cable
- CA-10DS Bi-directional Parallel Cable
- DAU-9T Service Cable
- Service Tools
- BACK TO MAIN PAGE
Issue 1 04/2005 COMPANY CONFIDENTIAL 17
Copyright © 2005 Nokia. All Rights Reserved.
RM-94
4 - Service Tools Nokia Customer Care
• both ends spring loaded test pin (used in lower part, can be replaced by hand after
disassembly of lower PCB)
Test pins (10pcs / plastic bag)
• fuse inside holder
Fuses (10 pcs)
•wing screw M3x20
Replacement part (1pc)
Usage hints
• Before first use, verify setting of power supply jumper on the rear (=bottom PCB)
of the jig; if power supply is >4.2 V, make sure jumper enables power regulation of
the jig in order to prevent overvoltage for the phone module under test and the jig.
• In case of flashing problems in the jig, verify the switch on the upper part of the
jig is in position “Flash”; position “Accessory” is intended for ACI tests with connected
ACI-communication enabled accessories, such as car kits or camera headsets.
• FM ANT (X7) is not applicable for RM-94.
• On left hand side there is a slit for IrDa.
• When shielding lids are removed from the shielding frame on the PWB, new
shielding lids must be used for proper closing of the shielding. It is not allowed to re-
use the removed ones.