User Guide

RM-94

Nokia Customer Care 6(b) - RF Troubleshooting

28 COMPANY CONFIDENTIAL Issue 1 04/2005

The setup should now look like this:

Now the measurement equipment should detect the following output signal of the phone:

out

= +21.5 dBm @ 1880 MHz

If this is not the case, then go to the EDGE fault finding chart for GSM1900 transmitter.

Fault finding chart for GSM1900 transmitter

In the following, it is assumed that the TXP signal is used as trigger signal. For that, a TXP

test point is provided.