User Guide

Issue 1 01/2005 COMPANY CONFIDENTIAL 55

RM-30

3 - Service Software and Tuning Instructions Nokia Customer Care

Adjust DAC Values for all power levels according to the target values:

The power levels may differ from the target power levels mentioned in Phoenix.

Make sure that the output power for Power Level 5 is equal or lower than 1dB below the satu-

ration output power. Determine the saturation power by setting the DAC value to its maximum,

for example, adjust the DAC Value to 32.3dBm for Power Level 5 if the saturation output power

is only 33.3dBm.

Check if all levels match the target values, correct if necessary and then press < Save & Con-

tinue >.

Tx power level tuning GSM900 in EDGE mode

On the popped up window press ok.

The setup should now look like this:

Adjust DAC Values for all power levels according to the target values.

TX PA Mode Power level Target power (dBm)

High 5 32.5

15 13

19 5

Base level -27