User Guide

6015/6015i/6016i/6019i (RH-55), 6012 (RM-20)
System Module Nokia Customer Care
Page 28 ©2004 Nokia Corporation Company Confidential Issue 1 - Revision 002 09/2004
General Testing Information
The phone has three different modes for test/repair. Modes can be selected with suitable
resistors connected to BSI lines as follows:
The MCU software enters automatically to Local or Test mode at start-up if
corresponding resistors are connected.
Note: The baseband does not wake up automatically when the battery voltage is connected (Normal
Mode).
RF Module
Supports CDMA 1900, CDMA 800, and AMPS as described in the following documents:
• IS2000-2-A Physical Layer Standard for cdma2000 Spread Spectrum Systems
• IS-98D Recommended Minimum Performance Standard for Spread Spectrum
Mobile Stations
• IS-98E Recommended Minimum Performance Standard for Spread Spectrum
Mobile Stations
• TIA/EIA-690 Recommended Minimum Standards for 800 MHz Cellular Subscriber
Units
Temperature Conditions
Adhere to the following surface temperature (SPR5 - Product Safety) guidelines:
• Maximum temperature rise is 50
o
C for nonmetallic surfaces and 30
o
C for metal
surfaces at room temperature
• Other temperature requirements (SPR4 - Operating Conditions)
• Meeting requirements: -30 to +60
o
C
• Storage requirements: -30 to +85
o
C
Table 14: Operating Modes
Mode BSI Resistor Notes
Normal 68k
Local 33k
Test 6.8k Recommended with baseband testing. Same as
Local mode, but making a phone call is possible.