User Guide

6015/6015i/6016i/6019i (RH-55), 6012 (RM-20)

Service Software Instructions Nokia Customer Care

Hardware Requirements

Installing Diego

Be sure to check the following items before installing Diego:

• An FLS-4 version dongle is attached to either the parallel port or the USB port

(if the computer supports USB). An FLS-2D may be used; however, the FLS-2D

does not support the new generation DCT-4 version phones.

• If the computer supports administrator rights (typically on NT and Windows 2000

installations), ensure that access is enabled for the user performing the

installation.

• If a previous version of Diego has been installed, remove that program prior to

installing the new version. Once removal is performed, be sure to reboot the

computer prior to continuing. (See the "Uninstalling Diego" section for

instructions on how to uninstall.)

Installing

Use the following steps to install Diego:

1. Insert the CD into the computer.

2. Navigate to the CD-ROM drive, and double-click the Diego software package.

3. Follow the on-screen prompts.

4. Reboot the computer when the installation is complete.

Software Support Bundles

The Diego installation program is a generic software load. In order to support specific

custom transceivers (customer-specific phone models), it is necessary to also obtain

Software Support Bundles. These bundles are created by Nokia Customer Care and made

available by Nokia After Market Services (AMS) for the Americas region on the Partners

Table 3: Minimum Hardware Requirements

Hardware Minimum Value

Processor 233 MHz

RAM1 64 MB

Disk space needed 50-100 MB

Table 4: Supported Operating System Information

Operating System Notes

Windows 98 SE only

Windows NT 4.0 No USB support

Windows 2000 Professional version