User Guide

4. From the Testing menu, select GPS Control. This opens up

GPS Control

dialogue box, as shown in the

figure below, and enables the GPS.

Figure 20 GPS Control dialogue box

Testing GPS

1 Select On to confirm that the GPS is enabled and powered up.

2 6. From the same RX Control tab, select from Simple Tests Receiver Self Test as a Test case.

a If it is a pass, proceed to step 7, otherwise proceed.

b If it is a fail, repeat the test. If it fails again, check connections. If this doesn’t help, swap engine module.

3 7. Go to Quick test -tab as shown below.

RM-465

BB Troubleshooting

Issue 1 COMPANY CONFIDENTIAL Page 3 –53