User Guide

PAMS
Technical Documentation
NSB–1/3
Service Software Instructions
Page 34
Original 06/98
Note! Function is activated immediately, Apply is not needed.
TX radio button (ALT+T):
When
TX is selected, the next functions are made:
Data transmission is activated
If operation mode is continuous,
– Operation mode is set to burst
RF Information window is updated
Continuous mode radio button is disabled.
Note! Function is activated immediately, Apply is not needed.
Operation Mode group:
Continuous radio button:
When
continuous selection is used,
synthesiser is set to constant frequency
synthesiser channel number is as given with Continuous Mode
Channel selection
transmitter power is not connected
if Active Unit is RX, AGC is controlled
Note! Function is activated immediately, Apply is not needed.
Burst radio button (ALT+B):
When
burst selection is used,
synthesiser is controlled by using receiving/transmission/mea-
suring synthesiser control sequence
synthesiser channel numbers are as given with Channel/Moni-
toring Channel selections
if Active Unit is TX, data (selected with TX Data Type) is sent
and the TX power is connected
Note! Function is activated immediately, Apply is not needed.
TX D
ata Type drop list (ALT+D):
TX Power Level edit box (ALT+X):
With this value is possible to change the transmission power. The user
can give the needed power value or select the test value, which is tuned
with TX power tuning function. The test value is found at the end of the
list.
TX Power have value
OFF and is disabled ( greyed ) when active unit is
RX. When the TX power is tuned with test value (smallest value) the TX
Power has value
TEST .