User Guide

Nokia Customer Care Troubleshooting Instructions
Company confidential NPL-4/5
Issue 1 05/04 Copyright © 2004 Nokia Corporation. All rights reserved. Page 39
-TX Data Type->Random
The setup should now look like this:
Figure 24: RF Control Values
Now the measurement equipment should detect the following output signal of the
phone:
P
out
= +23dBm @ 1747.8 MHz
If this is not the case, then go to the chapter GMSK for the troubleshooting.
EDGE
Select operation mode to the “local”.
Select->Testing -> RF control
In the popup window common values:
Active unit:->TX
Band:->1800
Operation mode: ->Burst
RX/TX Channel:->700
In the popup window TX control values:
EDGE:->ON