NPM-6 Series Transceivers Disassembly and Assembly Instructions Issue 1 01/03 CopyrightãNokia.
Disassembly and Assembly Instructions CCS Technical Documentation Disassembling instructions ............................................................................................ 4 Exchange of system connector....................................................................................... 6 Exchange of battery connector...................................................................................... 8 Page 2 Copyright ãNokia.
CCS Technical Documentation Disassembly and Assembly Instructions Disassembling instructions Note! It is only allowed to reassemble C-Cover (phone) once. For second reassembling use of new C-Cover is mandatory! Use new screws in general. Press the grip markings on both sides of the B-Shell and remove B-Shell. 3 4 1 2 To remove the A-Shell press Locking Springs as shown and pull A-Shell from the unit.
Disassembly and Assembly Instructions Remove Earpiece. Note the guiding pin when assembling Page 4 CCS Technical Documentation Remove Keymat. Copyright ãNokia.
CCS Technical Documentation Disassembly and Assembly Instructions Exchange of system connector The System Connector is attached with double-sided adhesive gasket to C-Cover. Also note the gasket on CCover. Press SRT-6 between C-Cover and System Connector and remove Battery Cover. Press again SRT-6 between C-Cover and System Connector and remove System Connector. Remove System Connector. To remove the remaining adhesive gasket use SRT-6 only. Do not use sharp-edged tools for this procedure.
Disassembly and Assembly Instructions Place System Connector to its guidance exactly. Page 6 CCS Technical Documentation Now press connector to C-Cover firmly, while taking care not to slip C-Cover on your table. Copyright ãNokia.
CCS Technical Documentation Disassembly and Assembly Instructions Exchange of battery connector These are the two soldered support angles. Use a side cutter to cut the support angles. Push tweezers in outer openings of battery connector and lift up the plastic cover. Desolder all pins and clean the pads. Note that you need a soldering iron with higher temperature, when cleaning or soldering the grounding pad. Tin one of pads to fix the connector before soldering the following pins.
Disassembly and Assembly Instructions Note location of connector pins and support angles to fit them precisely. Page 8 CCS Technical Documentation Solder first support angle. When position is exactly, solder the other pins. Copyright ãNokia.
