User Guide
Table Of Contents
- Amendment Record Sheet
- Copyright
- Warnings and cautions
- For your safety
- Care and maintenance
- ESD protection
- Battery information
- Company Policy
- Nokia 5000 Service Manual Structure
- 1 General Information
- 2 Service Devices and Service Concepts
- 3 Baseband Troubleshooting Instructions
- General baseband troubleshooting
- SIM related faults
- User interface
- Audio troubleshooting
- Audio troubleshooting using phoenix
- Check microphone using "Hp microphone in Ext speaker out" loop
- Check earpiece using "Ext microphone in Hp speaker out" loop
- Check IHF & ringing tone function using "Buzzer"
- Check vibra function using "Vibra control"
- Earpiece fault
- IHF/ringing tone fault
- Microphone fault
- Headset earpiece fault
- Headset microphone fault
- 4 RF Troubleshooting Instructions
- 5 Camera Module Troubleshooting
- 6 System Module
- Glossary
Easy flash programming does not work
Context
The flash programming can be done via the easy flash connector. If failed, then follow up the trouble shooting
below.
It is not possible to verify if there is a short circuit in control and address lines of MCU (UPP8M) and memory
(flash) because BGA package is used in RM-362/363.
RM-362; RM-363
Baseband Troubleshooting Instructions
Issue 1 COMPANY CONFIDENTIAL Page 3 –11
Copyright © 2008 Nokia. All rights reserved.