User Guide
Table Of Contents
- Amendment Record Sheet
- Copyright
- Warnings and cautions
- For your safety
- Care and maintenance
- ESD protection
- Battery information
- Company Policy
- Nokia 5000 Service Manual Structure
- 1 General Information
- 2 Service Devices and Service Concepts
- 3 Baseband Troubleshooting Instructions
- General baseband troubleshooting
- SIM related faults
- User interface
- Audio troubleshooting
- Audio troubleshooting using phoenix
- Check microphone using "Hp microphone in Ext speaker out" loop
- Check earpiece using "Ext microphone in Hp speaker out" loop
- Check IHF & ringing tone function using "Buzzer"
- Check vibra function using "Vibra control"
- Earpiece fault
- IHF/ringing tone fault
- Microphone fault
- Headset earpiece fault
- Headset microphone fault
- 4 RF Troubleshooting Instructions
- 5 Camera Module Troubleshooting
- 6 System Module
- Glossary
ST-30 Rework stencil
It is used together with RJ-51 to rework N7700.
ST-32 Rework stencil for
B2100
Rework stencil to be used together with RJ-72 for rework of N7600.
SX-4 Smart card
SX-4 is a BB5 security device used to protect critical features in tuning
and testing.
SX-4 is also needed together with FPS-10 when DCT-4 phones are
flashed.
XCS-4 Modular cable
XCS-4 is a shielded (one specially shielded conductor) modular cable
for flashing and service purposes.
XRS-6 RF cable
The RF cable is used to connect, for example, a module repair jig to
the RF measurement equipment.
SMA to N-Connector approximately 610 mm.
Attenuation for:
• GSM850/900: 0.3+-0.1 dB
• GSM1800/1900: 0.5+-0.1 dB
• WLAN: 0.6+-0.1dB
RM-362; RM-363
Service Devices and Service Concepts
Page 2 –12 COMPANY CONFIDENTIAL Issue 1
Copyright © 2008 Nokia. All rights reserved.