User Guide
Table Of Contents
- Amendment Record Sheet
- Copyright
- Warnings and cautions
- For your safety
- Care and maintenance
- ESD protection
- Battery information
- Company Policy
- Nokia 5000 Service Manual Structure
- 1 General Information
- 2 Service Devices and Service Concepts
- 3 Baseband Troubleshooting Instructions
- General baseband troubleshooting
- SIM related faults
- User interface
- Audio troubleshooting
- Audio troubleshooting using phoenix
- Check microphone using "Hp microphone in Ext speaker out" loop
- Check earpiece using "Ext microphone in Hp speaker out" loop
- Check IHF & ringing tone function using "Buzzer"
- Check vibra function using "Vibra control"
- Earpiece fault
- IHF/ringing tone fault
- Microphone fault
- Headset earpiece fault
- Headset microphone fault
- 4 RF Troubleshooting Instructions
- 5 Camera Module Troubleshooting
- 6 System Module
- Glossary
Service devices
The table below gives a short overview of service devices that can be used for testing, error analysis, and
repair of product RM-362; RM-363. For the correct use of the service devices, and the best effort of workbench
setup, please refer to various concepts.
CA-106DS Easy flash II cable
The cable is used for connecting phone DC port to the flash prommer
FPS-10.
CA-111DS Easy flash II cable
The cable is used for connecting phone DC port to either POS flashing
device FLS-4S or to the PROMMER box FPS-11.
CA-112DS Easy flash II cable
The CA-112DS easy flash II cable is used for connecting phone DC port
to the PROMMER facilities (FLS-5, FPS-20).
RM-362; RM-363
Service Devices and Service Concepts
Issue 1 COMPANY CONFIDENTIAL Page 2 –5
Copyright © 2008 Nokia. All rights reserved.