Users Manual Part 1

Nokia FastMile 4G Receiver Product Overview Power information
Issue: 01 3TG-01505-AAAB-TCZZA 71
11 Power information
11.1 Power information for the Nokia FastMile 4G Receiver
11.2 Available PoE injectors
11.1 Power information for the Nokia FastMile 4G
Receiver
The Nokia FastMile 4G Receiver receives power though a Cat5e shielded Ethernet
cable (or through a non-shielded Ethernet cable for the Model 4G17-A only) that
must be connected to a Nokia-approved residential gateway or to a Nokia-approved
PoE injector (see section 11.2 for information about PoE injectors available from
Nokia for use with the FastMile 4G Receiver).
• Compact mono-band and ABA models have a pre-attached Cat5e shielded
twisted pair Ethernet cable with a male RJ 45 connector at the free end. An
additional length of cat5e shielded Ethernet cabling can be attached to the
Ethernet cable up to a maximum of 80 m (262 ft) in combined length. A waterproof
IP67 female RJ 45 plug is needed to connect the Ethernet cabling to the Ethernet
cable of the Nokia FastMile 4G Receiver. See section 8.1 for more information
about the pre-attached Ethernet cable.
• Compact multi-band models and the High gain CBRS model have an Ethernet
port that has a female RJ 45 connector, and require a customer-supplied Ethernet
cable (See section 8.2 for more information about the Ethernet port):
• the Model 4G17-A has a floating ground design that supports a cat5e non-shielded
or shielded twisted pair Ethernet cable with standard pinouts that is up to a maximum
of 80 m (262 ft) in length
• all other Compact multi-band models and the High gain CBRS model require a cat5e
shielded Ethernet cable with standard pinouts that is a maximum of 80 m (262 ft) in
length
See section 12.4 for power consumption information.
11.2 Available PoE injectors
If the Nokia FastMile 4G Receiver is going to be powered through a PoE injector, the
PoE injector must be a Nokia-approved PoE injector.