Users Manual Part 1

Nokia FastMile 4G Receiver Product Overview LEDs
Issue: 01 3TG-01505-AAAB-TCZZA 69
10.2.2 Signal strength LEDs on the High gain CBRS model
Five signal strength LEDs are provided on the underside of the High gain CBRS
model of the Nokia FastMile 4G Receiver as shown in Figure 24.
Figure 24 Location of the signal strength LEDs on the High gain CBRS
model
The signal strength LEDs can be activated by pressing the measurement button on
the underside of the High gain CBRS model of the Nokia FastMile 4G Receiver.
Figure 25 shows the location of the measurement button.
Figure 25 Location of the measurement button on the High gain CBRS
model
The signal strength LEDs act as a set to indicate the LTE signal strength detected by
the Nokia FastMile 4G Receiver. For example, if the signal strength is fourth level,
then LEDs 1, 2, 3, and 4 are lit. Table 13 lists the threshold values for the signal
strength LEDs, but note that the threshold values can be changed through an ACS.
RESET
SIMPOETEST
Signal strength LEDs
36317
RESET
SIMPOETEST
Measurement
button
36318