User Guide

[ 51 ]
Tip: See also “Settings needed for multimedia messaging” on page 97,
“Settings needed for e-mail” on page 100, and “Set up the phone for
the mobile browser” on page 140.
Note: To be able to use a data connection, the network service provider
must support this feature, and if necessary, activate it for your SIM
card.
• Access point name (for packet data only) - The access point name is
needed to establish a connection to the GPRS network. You obtain the
access point name from your service provider.
• Dial-up number (for GSM data and high speed data only) - The modem
telephone number of the access point.
• User name - Write a user name if required by the service provider. The
user name may be needed to make a data connection, and is usually
provided by the service provider. The user name is often case-
sensitive.
Tip: When you are writing, press to open the special characters table.
Press to enter a space.
• Prompt password - If you must key in a new password every time you
log on to a server, or if you do not want to save your password to the
phone, choose Yes.
• Password - A password may be needed to make a data connection, and
is usually provided by the service provider. The password is often
case-sensitive. When you are writing the password, the characters
you enter are shown briefly and then changed to asterisks (*). The
easiest way to enter numbers is to press and select Insert number
and then continue entering letters.
• Authentication - Normal / Secure.
• Gateway IP address - The IP address that the required WAP gateway
uses.
• Homepage - Depending on what you are setting up, either write
• the WAP service address, or