User Guide

[ 33 ]
Running H/F 2
(PIC)If you have activated the Call waiting
service, the network will notify you of a new
incoming call while you have a call in
progress. See “Call waiting: (network service)”
on page 46.
1 During a call, press to answer the
waiting call. The first call is put on hold.
To switch between the two calls, press Swap.
2 To end the active call, press .
Tip: To end both calls at the same time, select Options→End all calls and
press OK.
Options during a call
Many options that you can use during a call are network services. Press
Options during a call for some of the following options:
Mute or Unmute, End active call, End all calls, Hold or Unhold, Handset, BT
handsfree, New call, Conference, Private, Drop participant, Answer, and
Decline.
Swap is used to switch between the active call and the call on hold
Transfer is used to connect an incoming call or a call on hold with an
active call and to disconnect yourself from both calls.
Send DTMF is used to send DTMF tone strings, for example, passwords or
bank account numbers.
1
Key in the digits with - . Each keystroke generates a DTMF tone,
which is transmitted while the call is active. Press repeatedly to
produce: *, p (inserts a pause of approx. two seconds before, or between
DTMF characters.), and w (if you use this character, the remaining
sequence is not sent until you press Send again during the call). Press
to produce #.
2 To send the tone, press OK.